Postby beew » 03 Dec 2015, 12:11
Hi,
I have build polymake 2.14r1 this time with the patch (instead of the beta), it sort of works better than before, jreality does start half of the time (before it never started) and the error message is also gone. But when jreality doesn't start killing java and rerun the command sometimes work, and if not deleting the config folder .polymake and restart polymake usually works. Not sure if this info is helpful.
Also as a suggestion, right now if I run a command like "$q -> VISIUAL;" polymake will jump to the next command prompt whether jreality starts or not. Sometimes it takes a while to start, sometimes never. There is no clue from looking at the terminal whether the command is successful. One can wait a while, jreality may open, or may not. I think it would be good if there is some clue, like the next prompt doesn't appear until jreality is successfully launched or output an error if it get stuck somehow.
Thanks.
P.S. I am using geomview for the viewer, works very well.